Setup guide

B-3
Cisco 6400 Software Setup Guide
OL-1183-04
AppendixB Upgrading Software on the Cisco 6400
Upgrading Software on Nonredundant NRP-1s
Step 11 If you set the config register to 0x0 in Step 8, you will see the rommon prompt after completion of the
NRP-1 reload. Complete the following steps to manually boot the NRP-1 and set it up for automatic
reboot.
a. Use the dir command to locate and identify the new image.
rommon 1 > dir flash:
b. Use the boot command to manually boot the NRP-1.
rommon 2 > boot flash:c6400r-g4p5-mz.122-13.T
Example—Upgrading the Nonredundant NRP-1
In the following example, the NRP-1 system image is upgraded from Cisco IOS Release 12.0(7)DC to
CiscoIOS Release 12.2(13)T:
Router# dir flash:
Directory of flash:/
1 -rw- 94074 Jul 26 2000 17:11:46 lns.cfg
2 -rw- 96278 Jul 26 2000 17:14:46 ip_route.cfg
3 -rw- 190480 Jul 27 2000 10:14:08 work.cfg
4 -rw- 5018040 Aug 08 2000 15:23:34 c6400r-g4p5-mz.120-7.DC
15990784 bytes total (10591396 bytes free)
Router# ping 10.2.16.99
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.2.16.99, timeout is 2 seconds:
.!!!!
Success rate is 80 percent (4/5), round-trip min/avg/max = 1/2/4 ms
Router# delete flash:c6400r-g4p5-mz.120-7.DC
Delete filename [c6400r-g4p5-mz.120-7.DC]?
Delete flash:c6400r-g4p5-mz.120-7.DC? [confirm]
Router# squeeze flash:
All deleted files will be removed. Continue? [confirm]
Squeeze operation may take a while. Continue? [confirm]
Squeezing...Erasing squeeze bufferWriting squeeze bufferErasing sector:2 Writing
sector:2Erasing squeeze log
Squeeze of flash complete
Router# copy tftp:flash:
Address or name of remote host []? 10.2.16.99
Source filename []? c6400r-g4p5-mz.122-13.T
Destination filename [c6400r-g4p5-mz.122-13.T]?
Accessing tftp://10.2.16.99/c6400r-g4p5-mz.122-13.T...
Loading c6400r-g4p5-mz.122-13.T from 10.2.16.99 (via
Ethernet0/0/1):!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
[snip]
!!!!!!!!
[OK - 5215272/10430464 bytes]
5215272 bytes copied in 87.740 secs (59945 bytes/sec)
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# no boot system flash c6400r-g4p5-mz.120-7.DC
Router(config)# boot system flash c6400r-g4p5-mz.122-13.T
Router(config)# config-register 0x2