Setup guide

IN-1
Cisco 6400 Software Setup Guide
OL-1183-04
INDEX
A
alarms
clearing 6-6
displaying status 6-5
displaying thresholds 6-5
overview 6-4
temperature 6-4
APS
disabling 5-19
enabling 5-19
overview 5-19
priority requests 5-20
signal BER thresholds 5-21
aps clear command 5-21
aps force command 5-21, 5-23
aps lockout command 5-21
aps manual command 5-21, 5-23
aps mode command 5-19
aps signal-degrade command 5-22
aps signal-fail command 5-22
archive tar /table command A-24
archive tar /xtract command A-3, A-24
associate slot command
configuring redundant NLCs 5-17
configuring redundant NRPs 5-15
associate subslot command 5-18
ATM
address on NSP
autoconfigured 2-4
configuring 2-5
MTU limitation on NRP-2 3-11to 3-13
routing 2-18
static route 2-18
atm address command 2-5
atm iisp command 4-7
atm ilmi-pvc-discovery command 3-26
atm input-xlate-table autominblock command C-5
atm input-xlate-table autoshrink command C-6
atm input-xlate-table minblock command C-4
atm maxvci-bits command 4-4, 4-5, 4-7
atm maxvpi-bits command 4-4, 4-5, 4-7
atm nni command 4-5
atm pvc command 2-11
atm pvp command 2-12
atm route command 2-18
atm route prefix command 4-7
atm uni command 4-4
atm vc-per-vp command 3-13
atm vc tx command 3-5
auto-ferf command 4-10
automatic FERF alarms, DS3 4-10
automatic protection switching
See APS
auto-sync command 5-4
B
BITS 2-16to2-18
boot system command
NRP B-2
NSP 5-13
bridge commands, NME consolidation 2-8
bridge-group command 2-8
building integrated timing supply
See BITS