Setup guide
2-2
Cisco 6400 Software Setup Guide
OL-1183-04
Chapter2 Basic NSP Configuration
Checking the Software Release Version
Note If your Telnet station or Simple Network Management Protocol (SNMP) network management
workstation and the Cisco 6400 are on different networks, you must add a static routing table entry to
the routing table. For information on configuring static routes, see the “Configuring ATM Routing and
PNNI” chapter of the ATM Switch Router Software Configuration Guide.
For general information on basic Cisco IOS configuration, see the Cisco IOS Configuration
Fundamentals Configuration Guide associated with your software release level.
Checking the Software Release Version
To check the software release version, connect a console terminal or a terminal server to the NSP console
port on the NSP faceplate. After you boot the NSP, the following information is displayed to verify that
the NSP has booted successfully.
Take note of the software release version included in the display. For information on upgrading to a
higher release version, see AppendixB, “Upgrading Software on the Cisco 6400.”
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) C6400 Software (C6400S-WP-M), Version 12.3
Copyright (c) 1986-2002 by Cisco Systems, Inc.
Compiled Tue 18-Sep-02 15:00 by jdoe
Image text-base: 0x60010908, data-base: 0x6069A000
FPGA VERSION: 97/11/25 22:11:51 1383107375 /rhino/fpga/fc_abr_fc3/xil/abr_fpga_r.bit
98/02/24 17:11:36 1332837880 /rhino/fpga/fc_stat_fpga/xilinx/stat_fpga_r.bit
97/11/13 10:03:51 1059421866 /rhino/fpga/fc_traffic_fc3/xil/upc_fpga.bit
97/08/06 13:09:19 288278431 /rhino/fpga/fc_netclk/xilinx/pll_cntl_r.bit
Initializing FC-PFQ hardware ... done.
cisco C6400S (R4600) processor with 131072K bytes of memory.
R4700 CPU at 100Mhz, Implementation 33, Rev 1.0
Last reset from s/w peripheral
2 Ethernet/IEEE 802.3 interface(s)
11 ATM network interface(s)
507K bytes of non-volatile configuration memory.
107520K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes).
8192K bytes of Flash internal SIMM (Sector size 256K).
Press RETURN to get started!