Setup guide

3-14
Cisco 6400 Software Setup Guide
OL-1183-04
Chapter3 Basic NRP Configuration
NRP-2 and NRP-2SV Configuration
Example
In the following example, the VCI range is set to 2048 values (0–2047):
!
interface ATM0/0/0
no ip address
atm vc-per-vp 2048
no atm ilmi-keepalive
!
Verifying the VPI and VCI Ranges
To verify successful configuration of the VPI and VCI ranges, complete one or both of the following
steps:
Step 1 Use the more system:running-config command in EXEC mode to check for successful configuration:
Router# more system:running-config
...
interface ATM0/0/0
no ip address
atm vc-per-vp 2048
...
Step 2 Use the show controller atm 0/0/0 command in privileged EXEC mode:
Router# show controller atm 0/0/0
...
*** SE64 General Data ***
SE64_MAX_TX_PTYPE_HOLDER = 49152
SE64_PARTICLE_POOL = 32255
VPI bits = 5
VCI bits = 11
SAR revision E
....
2048 0–2047 11 0–31 5 0–7 3
4096 0–4095 12 0–15 4 0–3 2
8192 0–8191 13 0–7 3 0–1 1
1. Notice that the smallest allowed number entry is 64. The next possible value would be 32 (VCI range 0–31), but VCI values
0 through 31 are reserved by the ATM Forum for particular functions (such as ILMI).
2. The VPI ranges and number of bits shown for the NRP-2SV apply to Cisco IOS Release 12.2(4)B, 12.2(13)T, 12.3, and later
releases. For the NRP-2SV running Cisco IOS Release 12.2(2)B, refer to the VPI ranges and number of bits shown for the
NRP-2.
Table3-3 Allowed Entries for the number Argument
number
1
VCI Range VCI Bits
NRP-2SV
2
NRP-2
VPI Range VPI Bits VPI Range VPI Bits