Instruction Manual

Appendix A Reference List of Parameters
Configuration Parameters
A-20
Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 5.0 (SIP), Cisco Unified IP Phones
OL-8131-01
NatTimer (not used in
Cisco Unified
CallManager release
5.0)
Retransmission interval (in seconds) for sending a dummy packet to the server
specified with the NatServer parameter, specified in bits 0-11 the parameter.
The upper 20 bits are reserved and should be set to 0.
Value type: Bitmap.
Default value: 0x00000000 (no dummy packets will be sent to NatServer)
DialPlan Dial plan rules. No syntax check is performed by the implementation. The
administrator must ensure that the dial plan is syntactically valid.
Value type: Alphanumeric string, up to 199 characters.
Default value: *St4-|#St4-|911|1>#t8.r9t2-|0>#t811.rat4-|^1t4>#.-
IPDialPlan (not used
in Cisco Unified
CallManager release
5.0)
Allows for detection of IP-like destination addresses in the dial plan:
• 1=If two periods (.) are detected, assume that this is an IP address.
• 2=If three periods (.) are detected, assume that this is an IP address.
Value type: Integer.
Default value: 1
Table A-5 SIP Parameters (continued)
Parameter Description