Operation Manual

5-7
Cisco Unified IP Phone 7975G Administration Guide for Cisco Unified Communications Manager 6.1
OL-14640-01
Chapter 5 Configuring Features, Templates, Services, and Users
Telephony Features Available for the Phone
Do Not Disturb (DND) When DND is turned on, no audible rings occur during the
ringing-in state of a call.
You can configure the phone to have a softkey template
with a DND softkey or a phone-button template with DND
as one of the selected features.
The following DND-related parameters are configurable in
Cisco
Unified Communications Manager Administration:
• Do Not Disturb—This checkbox allows you to enable
DND on a per-phone basis. Choose Device > Phone >
Phone Configuration.
• DND Incoming Call Alert—Choose the type of alert to
play on a phone for incoming calls when DND is
active. This parameter is located on both the Common
Phone Profile window and the Phone Configuration
window (Configuration window value takes
precedence).
• Include DND In BLF Status—Enables DND status to
override busy/idle state.
Note The user can use Cisco Unified Communications
Manager User Options pages to enable/disable
DND, and to change DND Incoming Call Alert and
DND Timeout settings.
Cisco Unified Communications
Manager Features and Services Guide,
“Do Not Disturb” chapter.
Extension Mobility
(SCCP phones only)
Allows a user to temporarily apply a phone number and
user profile settings to a shared Cisco Unified IP Phone by
logging into the Extension Mobility service on that phone.
Extension Mobility can be useful if users work from a
variety of locations within your company or if they share a
workspace with coworkers.
For more information, refer to the
Cisco Unified
Communications
Manager Features and Services
Guide, “Cisco Unified
Communications Manager Extension
Mobility” chapter.
Fast Dial Service Allows a user to enter a Fast Dial code to place a call. Fast
Dial codes can be assigned to phone numbers or Personal
Address Book entries. (See
“Services” in this table.)
For more information, refer to:
• Cisco Unified Communications
Manager Administration Guide,
“Cisco Unified IP Phone Services
Configuration” chapter.
• Cisco Unified Communications
Manager System Guide, “Cisco
Unified IP Phone Services”
chapter.
Forced authorization
codes (FAC)
(SCCP phones only)
Controls the types of calls that certain users can place. For more information, refer to the
Cisco Unified
Communications
Manager Features and Services
Guide, “Client Matter Codes and
Forced Authorization Codes” chapter.
Table 5-1 Telephony Features for the Cisco Unified IP Phone (continued)
Feature Description Configuration Reference