Data Sheet

© 2012 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. Page 6 of 7
Item Specification
●
32 MB flash
Input Power
Requirements
●
AP1600: 44 to 57 VDC
●
Power Supply and Power Injector: 100 to 240 VAC; 50 to 60 Hz
Powering Options
●
802.3af Ethernet Switch
●
Cisco AP1600 Power Injectors (AIR-PWRINJ4=, AIR-PWRINJ5=)
●
Cisco AP1600 Local Power Supply (AIR-PWR-B=)
Power Draw
●
AP1600: 12.95 W
Note: When deployed using PoE, the power drawn from the power sourcing equipment will be higher by some amount
dependent on the length of the interconnecting cable. This additional power may be as high as 2.45W, bringing the total
system power draw (access point + cabling) to 15.4W.
Warranty Limited Lifetime Hardware Warranty
Compliance Standards
●
Safety:
◦ UL 60950-1
◦ CAN/CSA-C22.2 No. 60950-1
◦ UL 2043
◦ IEC 60950-1
◦ EN 60950-1
●
Radio approvals:
◦ FCC Part 15.247, 15.407
◦ RSS-210 (Canada)
◦ EN 300.328, EN 301.893 (Europe)
◦ ARIB-STD 33 (Japan)
◦ ARIB-STD 66 (Japan)
◦ ARIB-STD T71 (Japan)
◦ AS/NZS 4268.2003 (Australia and New Zealand)
◦ EMI and susceptibility (Class B)
◦ FCC Part 15.107 and 15.109
◦ ICES-003 (Canada)
◦ VCCI (Japan)
◦ EN 301.489-1 and -17 (Europe)
◦ EN 60601-1-2 EMC requirements for the Medical Directive 93/42/EEC
●
IEEE Standard:
◦ IEEE 802.11a/b/g, IEEE 802.11n, IEEE 802.11h, IEEE 802.11d
●
Security:
◦ 802.11i, Wi-Fi Protected Access 2 (WPA2), WPA
◦ 802.1X
◦ Advanced Encryption Standards (AES), Temporal Key Integrity Protocol (TKIP)
●
EAP Type(s):
◦ Extensible Authentication Protocol-Transport Layer Security (EAP-TLS)
◦ EAP-Tunneled TLS (TTLS) or Microsoft Challenge Handshake Authentication Protocol Version 2 (MSCHAPv2)
◦ Protected EAP (PEAP) v0 or EAP-MSCHAPv2
◦ Extensible Authentication Protocol-Flexible Authentication via Secure Tunneling (EAP-FAST)
◦ PEAPv1 or EAP-Generic Token Card (GTC)
◦ EAP-Subscriber Identity Module (SIM)
●
Multimedia:
◦ Wi-Fi Multimedia (WMM
™
)
●
Other:
◦ FCC Bulletin OET-65C
◦ RSS-102