Datasheet

ManualsBrandsCisco ManualsNetworkingANT-4G-SR-OUT-TNC=

Table Of Contents

Cisco Integrated 4G Low-profile Outdoor Saucer Antenna (ANT-4G-SR-OUT-TNC)

CHAPTER

10-1

Cisco CGR 1000 and 2000 Series Connected Grid Antennas Guide

OL-26330-01

Cisco Integrated 4G Low-profile Outdoor Saucer

Antenna (ANT-4G-SR-OUT-TNC)

This document describes the Cisco Integrated 4G Low-profile Outdoor Saucer Antenna that is supported

on the Cisco CGR 1000 Series routers. It supports frequencies of 698 to 960 MHz, 1575 MHz, and 1710

to 2700 MHz for the GSM, DCS, UMTS, and LTE/WiMAX frequency bands. In addition, this document

provides the antenna specifications and mounting instructions of the antenna.

Caution Read the information in Safety Precautions, page 1-15 before installing or replacing antennas.

This chapter covers the following topics:

• Technical Specifications, page 10-1

• Installation Requirements, page 10-5

• Safety Warnings, page 10-6

• Antenna Installation, page 10-7

• Obtaining Documentation and Submitting a Service Request, page 10-8

Technical Specifications

The Integrated 4G Low-profile Outdoor Saucer Antenna features the following:

• Applicable for both 3G and 4G solutions

• Domestic LTE 700 band and Global LTE 2600 band

• Domestic Cellular and Global GSM

• Weatherproof UV stable radome

• Performance optimized

• Excellent flame rating

Summary of content (10 pages)

PAGE 1
CH A P T E R 10 Cisco Integrated 4G Low-profile Outdoor Saucer Antenna (ANT-4G-SR-OUT-TNC) This document describes the Cisco Integrated 4G Low-profile Outdoor Saucer Antenna that is supported on the Cisco CGR 1000 Series routers. It supports frequencies of 698 to 960 MHz, 1575 MHz, and 1710 to 2700 MHz for the GSM, DCS, UMTS, and LTE/WiMAX frequency bands. In addition, this document provides the antenna specifications and mounting instructions of the antenna.
PAGE 2
Chapter 10 Cisco Integrated 4G Low-profile Outdoor Saucer Antenna (ANT-4G-SR-OUT-TNC) Technical Specifications Low-Profile Saucer Antenna 300637 Figure 10-1 RF Specifications Specification Description Frequency range Peak gain w/1-ft cable Peak gain w/15 -ft cable Average efficiency w/1-ft cable Average efficiency w/15-ft cable • 698 to 960 MHz • 1710 to 2700 MHz • 1.5 dBi (698 to 960 MHz) • 3.7 dBi (1710 to 2700 MHz) • 0.8 dBi (698 to 960 MHz) • 0.
PAGE 3
Chapter 10 Cisco Integrated 4G Low-profile Outdoor Saucer Antenna (ANT-4G-SR-OUT-TNC) Technical Specifications Mechanical Specifications Specification Description H-plane 3 dB beamwidth Omnidirectional Polarization Linear, vertical Nominal impedance 50 ohm Power 3 watts Cable 15 ft LMR 195 RF connector Type N (f), TNC (m) available Mount Style Ceiling mount Radome PC/ABS, UV stable, black Material substance compliance RoHS compliant Operational temperature -22 to 158 degrees F (-30 to
PAGE 4
Chapter 10 Cisco Integrated 4G Low-profile Outdoor Saucer Antenna (ANT-4G-SR-OUT-TNC) Technical Specifications Radiation Patterns The following graphics show the radiation patterns of the saucer antenna.
PAGE 5
Chapter 10 Cisco Integrated 4G Low-profile Outdoor Saucer Antenna (ANT-4G-SR-OUT-TNC) Installation Requirements Installation Requirements Antenna Connections Before you install or replace antennas, make sure the router is: • Powered off • Disconnected from all power sources • Disconnected from the Field Area Network (FAN) • Removed from a pole-top installation Optimum Performance Antennas transmit and receive radio signals which are susceptible to RF obstructions and common sources of interference
PAGE 6
Chapter 10 Cisco Integrated 4G Low-profile Outdoor Saucer Antenna (ANT-4G-SR-OUT-TNC) Safety Warnings Note Ensure that you are able to access the antenna port from inside the router. If an installed module prevents you from reaching the antenna port, you might have to remove the module before installing the antenna, then reinstall the module. See the corresponding module installation and configuration guide for each module.
PAGE 7
Chapter 10 Cisco Integrated 4G Low-profile Outdoor Saucer Antenna (ANT-4G-SR-OUT-TNC) Antenna Installation Warning This product is not intended to be directly connected to the Cable Distribution System. Additional regulatory compliance and legal requirements may apply for direct connection to the Cable Distribution System. This product may connect to the Cable Distribution System ONLY through a device that is approved for direct connection.
PAGE 8
Chapter 10 Obtaining Documentation and Submitting a Service Request Cisco Integrated 4G Low-profile Outdoor Saucer Antenna (ANT-4G-SR-OUT-TNC) Step 1 Determine the installation location on the wall of the utility cabinet. Step 2 Create the center hole to accommodate the threaded center rod and the three mounting holes of the saucer antenna. Secure the antenna onto the ceiling with the 3 screws using a Phillips #2 screwdriver. Step 3 From inside the utility cabinet space, secure the antenna.
PAGE 9
Chapter 10 Cisco Integrated 4G Low-profile Outdoor Saucer Antenna (ANT-4G-SR-OUT-TNC) Obtaining Documentation and Submitting a Service Request http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html Subscribe to the What’s New in Cisco Product Documentation as an RSS (Really Simple Syndication) feed, and set it so content is delivered directly to your desktop using a reader application. The RSS feeds are a free service and Cisco currently supports RSS Version 2.0.
PAGE 10
Chapter 10 Obtaining Documentation and Submitting a Service Request Cisco Integrated 4G Low-profile Outdoor Saucer Antenna (ANT-4G-SR-OUT-TNC) Cisco CGR 1000 and 2000 Series Connected Grid Antennas Guide 10-10 OL-26330-01