Installation guide

ManualsBrandsCisco ManualsComputer equipmentAS5350XM

CHAPTER

2-1

Cisco AS5350XM Universal Gateway Chassis Installation Guide

OL-6417-02

Preparing to Install the Cisco AS5350XM

Universal Gateway

This chapter describes the tasks you must perform before you begin to install the Cisco AS5350XM

universal gateway and includes the following sections:

• Safety Recommendations, page 2-1

• Required Tools and Equipment, page 2-3

• Preparing to Connect to a Network, page 2-3

Safety Recommendations

Any device that uses electricity must be handled carefully; follow these guidelines to ensure general

safety:

• Keep the chassis area clear and dust-free during and after installation.

• Put the removed chassis cover in a safe place.

• Keep tools away from walk areas where you and others could fall over them.

• Do not wear loose clothing that could get caught in the chassis. Fasten your tie or scarf and roll up

your sleeves.

• Wear safety glasses if you are working under any conditions that might be hazardous to your eyes.

• Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.

Warning

Ultimate disposal of this product should be handled according to all national laws and regulations.

Statement 1040

Maintaining Safety with Electricity

Warning

Before working on equipment that is connected to power lines, remove jewelry (including rings,

necklaces, and watches). Metal objects will heat up when connected to power and ground and can

cause serious burns or weld the metal object to the terminals. Statement 43

Follow these guidelines when you work on equipment powered by electricity.

Summary of content (6 pages)

PAGE 1
C H A P T E R 2 Preparing to Install the Cisco AS5350XM Universal Gateway This chapter describes the tasks you must perform before you begin to install the Cisco AS5350XM universal gateway and includes the following sections: • Safety Recommendations, page 2-1 • Required Tools and Equipment, page 2-3 • Preparing to Connect to a Network, page 2-3 Safety Recommendations Any device that uses electricity must be handled carefully; follow these guidelines to ensure general safety: Warning • Keep the c
PAGE 2
Chapter 2 Preparing to Install the Cisco AS5350XM Universal Gateway Safety Recommendations • Locate the emergency power-OFF switch for the room in which you are working. Then, if an electrical accident occurs, you can act quickly to turn OFF the power. • Before working on the system, unplug the power cord.
PAGE 3
Chapter 2 Preparing to Install the Cisco AS5350XM Universal Gateway Required Tools and Equipment Required Tools and Equipment The following items are included with the universal gateway: • 19- (48.26-) and 24-inch (60.
PAGE 4
Chapter 2 Preparing to Install the Cisco AS5350XM Universal Gateway Preparing to Connect to a Network Warning The ISDN connection is regarded as a source of voltage that should be inaccessible to user contact. Do not attempt to tamper with or open any public telephone operator (PTO)-provided equipment or connection hardware. Any hardwired connection (other than by a nonremovable, connect-one-time-only plug) must be made only by PTO staff or suitably trained engineers.
PAGE 5
Chapter 2 Preparing to Install the Cisco AS5350XM Universal Gateway Preparing to Connect to a Network Auxiliary Port The Cisco AS5350XM universal gateway includes an EIA/TIA-232 asynchronous serial auxiliary port (RJ-45) that supports flow control. Depending on the cable and the adapter used, this port will appear as a DTE or DCE device at the end of the cable. Your universal gateway arrives with a cable and an adapter to connect a modem to the auxiliary port.
PAGE 6
Chapter 2 Preparing to Install the Cisco AS5350XM Universal Gateway Preparing to Connect to a Network Power Supply Considerations Check the power at your site to ensure that you are receiving “clean” power (free of spikes and noise). Install a power conditioner if necessary. Warning The device is designed to work with TN power systems. Statement 19 Warning This product relies on the building’s installation for short-circuit (overcurrent) protection.