Specifications

Chapter 3 Configuring the Cisco ATA 186
Using the Web Configuration Page
3-4
Cisco ATA 186 Installation and Configuration Guide
OL-1267-01
Using the Voice Configuration Menu
To manually configure the Cisco ATA 186 by using the interactive voice
response (IVR) system and telephone keypad, follow the steps in this section. For
a list of the available configuration options, see Appendix A, “Voice Menu
Options.”
Step 1 Lift the handset and press the Function button located on top of the
Cisco ATA 186.
Step 2 Enter the IVR menu number for the parameter that you want to configure or the
command that you want to execute; then, press the pound key (#). (See
Appendix A, “Voice Menu Options,” and Appendix B, “Parameters and
Defaults,” for lists of options and their corresponding menu numbers.)
Step 3 Follow the applicable prompts.
Step 4 When you have finished, make sure you press 3 to save your changes.
Step 5 Hang up the telephone. The Cisco ATA 186 resets.he function button will
fast-blink when the reset is complete.
Using the Web Configuration Page
You can configure your Cisco ATA 186 by using the web configuration page.
Each configurable parameter is listed, and parameters are grouped and
color-coded according to their function.
Caution Cisco recommends you do not perform the initial configuration over the
Internet; the configuration page is not secure. After you have configured the
parameters, password-protect the user interface to prevent it from being
accessed on the Internet. The parameter for password-protecting this page is
UIPasswd.
Follow these steps: