User`s guide

Cisco ATA 186 Configuration Guide
2; to save, press 3; to review your saved value, press 4; or press the
pound key (#) to exit.”
4. Save the setting by pressing 3 on the telephone keypad.
You will hear a voice prompt that says, ”Value saved. Configuration
Menu…”
Without hanging up the telephone, continue with the following steps to
configure the PIN for port 1.
To configure the PIN for port 1:
1. Access the PORT 1 PIN MENU by pressing 4# on the telephone keypad.
You will hear a voice prompt that says, “Enter alphanumeric value.”
2. Enter the PIN one digit at a time, followed by the “#” key after each
digit. When you enter the final digit, press the # key twice.
• For example, to enter the PIN “9876,” you would press
9#8#7#6##.
You will hear a voice prompt that says, ”You entered ‘xxxx’ (where
xxxx is the PIN). To change, press 1; to review, press 2; to save,
press 3; to review your saved value, press 4; or press the pound key
(#) to exit.”
3. Save the setting by pressing 3 on the telephone keypad.
You will hear a voice prompt that says, ”Value saved. Configuration
Menu…”
If you have an account for port 2, you will need to configure it, as well.
CONFIGURING PORT 2
IMPORTANT: Unless you have a multi-user account, the
Net2Phone account number that you enter for port 2 should
be different from the account entered for port 1.
To configure the account for port 2:
1. Pick up the telephone handset, and press the button on top of the ATA
186.
You will hear a voice prompt that says, “Configuration Menu. Enter
menu number followed by the # key…”
2. Access the PORT 2 ACCOUNT NUMBER menu by pressing 47# on the
telephone keypad.
You will hear a voice prompt that says, “Enter alphanumeric value.”
3. Enter the account number one digit at a time, followed by the “#” key
after each digit. When you enter the final digit, press the # key
twice.
• For example, to enter the account number “123456789,” you
would press 1#2#3#4#5#6#7#8#9##.
You will hear a voice prompt that says, ”You entered ‘xxxxx’ (where
xxxxx is the account number). To change, press 1; to review, press
2; to save, press 3; to review your saved value, press 4; or press the
pound key (#) to exit.”
Page 11