User`s guide

Cisco ATA 186 Configuration Guide
Manual Configuration via Web Configuration Page
In the manual configuration, you must upgrade your ATA to the latest SIP
firmware on your own, and then manually enter the appropriate values into
each field.
The firmware version of the ATA 186 you will be using must be SIP 3.1.0 or
higher. If you have a previous version, contact Cisco or the party from
whom you obtained the device for an upgrade.
ENTERING PARAMETERS
To enter parameters via the Web Configuration page:
1. Open a Web browser and enter the following address:
http://xxx.xxx.xxx.xxx/dev.
(“xxx.xxx.xxx.xxx” represents the IP address of your ATA 186).
2. Enter the appropriate values for the configuration fields (see the Cisco
ATA 186 Configuration Page table on the following page) and then
click the Apply button when finished.
The ATA 186 will restart (reboot).
NOTE: The bold items in the table indicate which fields are
required.
Page 13