Specifications

3-6
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for SCCP (version 3.0)
OL-4652-01
Chapter 3 Configuring the Cisco ATA for SCCP
Steps Needed to Configure the Cisco ATA
Basic Configuration Steps in a Non-TFTP Server Environment
Table 3-4 shows the basic steps for configuring the Cisco ATA without using the TFTP server method.
3. Configure the method with which the Cisco ATA will locate the
Cisco
CallManager TFTP server at boot up time.
Configuring the Cisco ATA to Obtain its
Configuration File from the TFTP Server, page
3-18
4. Add the Cisco ATA to the Cisco CallManager. Chapter 4, “Adding the Cisco ATA to the
Cisco CallManager”
5. Power up the Cisco ATA .
6. Optionally, create a configuration file for a specific Cisco ATA. Creating a Configuration File for a Specific
Cisco ATA, page 3-11
7. If you make configuration changes to the Cisco ATA, you must reset
the Cisco
ATA by using the Cisco CallManager administration web
pages.
Resetting the Cisco ATA U s i n g
Cisco CallManager, page 3-26
Table 3-3 Basic Steps to Configure the Cisco ATA in a Typical Cisco CallManager Environment
Action Reference
Ta b l e 3-4 Basic Steps to Configure the Cisco ATA Without Using the TFTP Server Method
Action Reference
1. Download the desired Cisco ATA release software zip file from the Cisco web site:
a. If you are a registered CCO user. go to the following URL:
http://www.cisco.com/cgi-bin/tablebuild.pl/ata186
b. Download the zip file that contains the software for the applicable release and signaling
image you are using. The contents of each file are described next to the file name.
c. Extract the files to the desired location on your PC.
Note The file that contains the protocol signaling image has an extension of .zup.
2. Manually upgrade the Cisco ATA to the correct signaling image. Upgrading the Signaling
Image Manually, page 7-4
3. Configure the Cisco ATA by using either one of the manual-configuration methods. • Voice Configuration
Menu, page 3-22
• Cisco ATA We b
Configuration Page,
page 3-25
4. Manually configure the CA0orCM0 parameter to instruct the Cisco ATA about how to
register with Cisco
CallManager.
CA0orCM0 and
CA1orCM1, page 5-12
5. Power up the Cisco ATA .