Specifications

3-21
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for SCCP (version 3.0)
OL-4652-01
Chapter 3 Configuring the Cisco ATA for SCCP
Configuring the Cisco ATA Using a TFTP Server
Without Using a DHCP Server
Use the following procedure if you are not using a DHCP server in your environment but are still using
a TFTP server to obtain the Cisco
ATA configuration file:
Procedure
Step 1 Set the DHCP parameter to 0.
Step 2 Set the UseTftp parameter to 1.
Step 3 Set the Cisco ATA parameter TftpURL to the IP address or URL of the TFTP server. For more
information on setting the TftpURL parameter, see the
“TftpURL” section on page 5-4.
Note If you are not using a DHCP server to provide the TFTP server location, you must manually enter
the TftpURL using either the voice configuration menu or the web configuration page.
Step 4 If applicable, set the Cisco ATA parameter AlttftpURL to the IP address or URL of the alternate TFTP
server. For more information about the AlttftpURL parameter, see the
“AlttftpURL” section on
page 5-5.
Step 5 If you have not already done so, statically configure the following parameters using the voice
configuration menu (see the
“Voice Configuration Menu” section on page 3-22). These are the
parameters you need to configure for the Cisco ATA to obtain network connectivity:
• StaticIP
• StaticRoute
• StaticNetMask
Other parameters that are normally supplied by DHCP may be provided statically by configuring their
values. These parameters are:
• DNS1IP
• DNS2IP
• Domain
This completes the parameter settings you need to configure in order for the Cisco ATA to contact the
TFTP server (without using DHCP) that will contain the configuration file for the Cisco
ATA.