Specifications

5-21
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for SCCP (version 3.0)
OL-4652-01
Chapter 5 Parameters and Defaults
Operational Parameters
ConnectMode
Description
This parameter is a 32-bit bitmap to control the connection mode of the selected call signaling protocol.
Table 5-2 provides bit definitions for this parameter.
Value Type
Bitmap
Default
0x90000400
Voice Configuration Menu Access Code
311
Related Parameters
• AudioMode, page 5-16
• LBRCodec, page 5-13
Ta b l e 5-2 ConnectMode Parameter Bit Definitions
Bit Number Definition
0 0—Use the Cisco CallManager Cisco IP Telephony Locale Installer feature for the configuration of
Cisco
ATA tone parameters. For more information, see the “Using the Cisco IP Telephony Network Locale
Option” section on page 4-5.
Note The version of Cisco CallManager must be 3.3(3) or later and must contain Cisco IP Telephony
Locale Installer.
1—Use the Cisco ATA call-progress tone parameter configuration to override the Cisco CallManager tone
configuration parameters. For more information, see the
“Tone Configuration Parameters” section on
page 5-26.
Default: 0
1 Reserved.
2 0—Use the dynamic payload type 126/127 as the RTP payload type (fax pass-through mode) for G.711
µ-law/G.711 A-law.
1—Use the standard payload type 0/8 as the RTP payload type (fax pass-through mode) for G.711
µ-law/G.711 A-law.
Default: 0
3-6 Reserved.
7 0/1—Disable/enable fax pass-through redundancy.
Default: 0
8-12 Specifies the fax pass-through NSE payload type. The value is the offset to the NSE payload base number of
96. The valid range is 0-23; the default is 4.
For example, if the offset is 4, the NSE payload type is 100.