System information
Table Of Contents
- Getting Started with the Cisco SPA100 Series Phone Adapters
- Quick Setup for Voice over IP Service
- Configuring the Network
- Configuring Voice
- Administration Settings
- Viewing the Status and Statistics
- Frequently Asked Questions
- Using the IVR for Administration
- Installation Options
- Where to Go From Here
Configuring Voice
Configuring Voice Settings
Cisco SPA100 Series Phone Adapters Administration Guide 101
4
Streaming Audio Server (SAS)
Feature Dial Serv Enable Feature Dial Service. See the Feature Dial
Services Codes parameter For more information.
Default setting: Yes
Service Announcement
Serv
Enable Service Announcement Service. Default
setting: no
Field Description
SAS Enable To enable the use of the line as a streaming audio
source, select yes. Otherwise, select no. If
enabled, the line cannot be used for outgoing
calls. Instead, it auto-answers incoming calls and
streams audio RTP packets to the caller. Default
setting: no.
SAS DLG Refresh Intvl If this value is not zero, it is the interval at which
the streaming audio server sends out session
refresh (SIP re-INVITE) messages to determine
whether the connection to the caller is still active.
If the caller does not respond to the refresh
message, the ATA ends this call with a SIP BYE
message. The range is 0 to 255 seconds (0
means that the session refresh is disabled)
Default setting: 30.
Field Description