System information

Administration Settings
Factory Defaults
Cisco SPA100 Series Phone Adapters Administration Guide 127
5
Traceroute Test
Use the Administration > Diagnostics > Traceroute page to view the route
between the ATA and a destination.
To open this page: Click Administration in the menu bar, and then click
Diagnostics > Traceroute Test in the navigation tree.
STEP 1 Enter the IP address or domain name of the destination.
STEP 2 Click Start to Traceroute to start the test. The results appear on the page and are
refreshed every 5 seconds. During the test, you can click Stop to abandon the test.
The results display up to 30 hops.
STEP 3 Click Close to close the results and display the Traceroute Test form.
Factory Defaults
Use the Administration > Factory Defaults page to reset the ATA to the default
configuration. Alternatively, press and hold the RESET button for 20 seconds. All
user-changeable non-default settings will be lost. This may include network and
service provider data.
To open this page: Click Administration in the menu bar, and then click Factory
Defaults in the navigation tree.
You can perform the following tasks:
• Restore Router Factory Defaults: Choose Yes to remove any custom data
(router) settings that you have configured. The default settings will be
restored when you click Submit.
• Restore Voice Factory Defaults: Choose Yes. to remove any custom
settings that you configured on the Voice pages of the configuration utility.
The default settings will be restored when you click Submit.