System information
Table Of Contents
- Getting Started with the Cisco SPA100 Series Phone Adapters
- Quick Setup for Voice over IP Service
- Configuring the Network
- Configuring Voice
- Administration Settings
- Viewing the Status and Statistics
- Frequently Asked Questions
- Using the IVR for Administration
- Installation Options
- Where to Go From Here
Configuring the Network
Basic Setup
Cisco SPA100 Series Phone Adapters Administration Guide 20
3
Network Settings for the LAN and DHCP Server (SPA122
Only)
Use the Network Setup > Basic Setup > Network Settings page to set the IP
address and subnet mask for your local network. Also configure the settings for
the built-in DHCP server.
To open this page: Click Network Setup in the menu bar, and then click Basic
Setup > Network Settings in the navigation tree.
Enter the settings as described below. After making changes, click Submit to save
your settings, or click Cancel to abandon any unsaved entries.
Router IP
Enter the IP address and subnet mask for your local network. The default setting is
192.168.15.1/24.
DHCP Server Setting
Field Description
DHCP Server The ATA can use the built-in DHCP server to dynamically
assign IP addresses to connected devices. Click
Enabled to enable the DHCP server, or click Disabled to
disable this feature.