System information

Configuring the Network
Basic Setup
Cisco SPA100 Series Phone Adapters Administration Guide 24
3
Time Settings
Use the Network Setup > Basic Setup > Time Settings page to set the time for
the ATA. You can configure the system time manually or configure it by using the
Network Time Protocol (NTP) server.
To open this page: Click Network Setup in the menu bar, and then click Basic
Setup > Time Settings in the navigation tree. After making changes, click Submit
to save your settings, or click Cancel to abandon any unsaved entries.
User Manual
To set up the system clock manually, select User Manual and then enter the date
and time.
Time Zone
To use a time server to establish the time settings, select Time Zone. Then
complete the fields in this section.
Field Description
Date Enter the date in the following order: year, month, day.
Time Enter the time in the following order: hour (from 1 to 24),
minutes, and seconds.
Field Description
Time Zone Choose the time zone for the site where the ATA is in
operation.
Adjust Clock for
Daylight Saving
Changes
Check the box if you want to automatically adjust the
time when Daylight Savings Time is in effect. Otherwise,
uncheck the box.
Time Ser ver
Address
To use the ATA’s default Network Time Protocol (NTP)
server, select Auto from the drop-down list. This is the
default setting. If you want to specify the NTP server,
select Manual, and enter the domain name or IP
address of the NTP server that you want to use.