System information
Table Of Contents
- Getting Started with the Cisco SPA100 Series Phone Adapters
- Quick Setup for Voice over IP Service
- Configuring the Network
- Configuring Voice
- Administration Settings
- Viewing the Status and Statistics
- Frequently Asked Questions
- Using the IVR for Administration
- Installation Options
- Where to Go From Here
Configuring Voice
Configuring Voice Settings
Cisco SPA100 Series Phone Adapters Administration Guide 52
4
Configuring Voice Settings
Use the Voice pages to view and configure the voice settings for your ATA. These
pages are described in the following sections:
• Voice System Information
• Voice System Settings
• Voice Provisioning Settings
• SIP Settings
• Voice System Regional Settings
• Line 1 and Line 2 Settings (PHONE1 and PHONE2)
• User Settings (User 1 and User 2)
Voice System Information
Use the Voice > Information page to view information about the ATA voice
application.
To open this page: Click Voice on the menu bar, and then click Information in the
navigation tree.
Enter the settings as described below. After making changes, click Submit to save
your settings, or click Cancel to abandon any unsaved entries.
Product Information
Field Description
Product Name Model number/name.
Serial Number Product serial number.
Software Version Software version number.
Hardware Version Hardware version number.
MAC Address MAC Address. For example: 8843E1657936.
Client Certificate Status of the client certificate, which can indicate if
the ATA was authorized by your ITSP.