System information
Table Of Contents
- Getting Started with the Cisco SPA100 Series Phone Adapters
- Quick Setup for Voice over IP Service
- Configuring the Network
- Configuring Voice
- Administration Settings
- Viewing the Status and Statistics
- Frequently Asked Questions
- Using the IVR for Administration
- Installation Options
- Where to Go From Here
Configuring Voice
Configuring Voice Settings
Cisco SPA100 Series Phone Adapters Administration Guide 55
4
Call 1 and 2 State Can take one of the following values:
• Idle
• Collecting PSTN Pin
• Invalid PSTN PIN
• PSTN Caller Accepted
• Connected to PSTN
Call 1 and 2 Tone Type of tone used by the call.
Call 1 and 2 Encoder Codec used for encoding.
Call 1 and 2 Decoder Codec used for decoding.
Call 1 and 2 FAX Status of the fax pass-through mode.
Call 1 and 2 Type Direction of the call. May take one of the following
values:
• PSTN Gateway Call = VoIP-To-PSTN Call
• VoIP Gateway Call = PSTN-To-VoIP Call
• PSTN To Line 1 = PSTN call ring through
and answered by Line 1
• Line 1 Forward to PSTN Gateway = VoIP
calls Line 1 then forwarded to PSTN GW
• Line 1 Forward to PSTN Number =VoIP
calls Line 1 then forwarded to PSTN
number
• Line 1 To PSTN Gateway
• Line 1 Fallback To PSTN Gateway
Call 1 and 2 Remote Hold Indicates whether the far end has placed the call
on hold.
Call 1 and 2 Callback Indicates whether the call was triggered by a call
back request.
Call 1 and 2 Peer Name Name of the peer phone.
Field Description