System information

Configuring Voice
Configuring Voice Settings
Cisco SPA100 Series Phone Adapters Administration Guide 61
4
Firmware Upgrade
Report Rule The target URL to which configuration reports are sent.
This parameter has the same syntax as the Profile_Rule
parameter, and resolves to a TCP/IP command with an
associated URL.
A configuration report is generated in response to an
authenticated SIP NOTIFY message, with Event: report.
The report is an XML file containing the name and value
of all the device parameters.
This parameter may optionally contain an encryption
key.
For example:
[ --key $K ] tftp://ps.callhome.net/$MA/rep.xml.enc
Default setting: (empty)
Upgrade Enable Enables firmware upgrade operations independently of
resync actions. Default setting: Yes
Upgrade Error Retry
Delay
The upgrade retry interval (in seconds) applied in case
of upgrade failure. The ATA has a firmware upgrade
error timer that activates after a failed firmware upgrade
attempt. The timer is initialized with the value in this
parameter. The next firmware upgrade attempt occurs
when this timer counts down to zero. Default setting:
3600 seconds.
Downgrade Rev
Limit
Enforces a lower limit on the acceptable version number
during a firmware upgrade or downgrade. The ATA does
not complete a firmware upgrade operation unless the
firmware version is greater than or equal to this
parameter. Default setting: (empty)
Upgrade Rule This parameter is a firmware upgrade script with the
same syntax as Profile_Rule. Defines upgrade
conditions and associated firmware URLs. Default
setting: (empty)
Field Description