System information
Table Of Contents
- Getting Started with the Cisco SPA100 Series Phone Adapters
- Quick Setup for Voice over IP Service
- Configuring the Network
- Configuring Voice
- Administration Settings
- Viewing the Status and Statistics
- Frequently Asked Questions
- Using the IVR for Administration
- Installation Options
- Where to Go From Here
Configuring Voice
Configuring Voice Settings
Cisco SPA100 Series Phone Adapters Administration Guide 89
4
Caller ID Method The choices are described below. Default setting:
Bellcore(N.Amer, China)
• Bellcore (N.Amer,China): CID, CIDCW, and
VMWI. FSK sent after first ring (same as ETSI FSK
sent after first ring) (no polarity reversal or DTAS)
• DTMF (Finland, Sweden): CID only. DTMF sent
after polarity reversal (and no DTAS) and before
first ring.
• DTMF (Denmark): CID only. DTMF sent before
first ring with no polarity reversal and no DTAS.
• ETSI DTMF: CID only. DTMF sent after DTAS (and
no polarity reversal) and before first ring.
• ETSI DTMF With PR: CID only. DTMF sent after
polarity reversal and DTAS and before first ring.
• ETSI DTMF After Ring: CID only. DTMF sent after
first ring (no polarity reversal or DTAS)
• ETSI FSK: CID, CIDCW, and VMWI. FSK sent
after DTAS (but no polarity reversal) and before
first ring. Waits for ACK from a device after DTAS
for CIDCW.
• ETSI FSK With PR (UK): CID, CIDCW, and VMWI.
FSK is sent after polarity reversal and DTAS and
before first ring. Waits for ACK from a device after
DTAS for CIDCW. Polarity reversal is applied only
if equipment is on hook.
• DTMF (Denmark) with PR: CID only. DTMF sent
after
polarity reversal (and no DTAS) and before first
ring.
Default setting: Bellcore(N.Amer, China)
FXS Port Power
Limit
The choices are from 1 to 8. Default setting: 3
Caller ID FSK
Standard
The ATA supports bell 202 and v.23 standards for caller
ID generation. Default setting: bell 202
Field Description