System information
Table Of Contents
- Getting Started with the Cisco SPA100 Series Phone Adapters
- Quick Setup for Voice over IP Service
- Configuring the Network
- Configuring Voice
- Administration Settings
- Viewing the Status and Statistics
- Frequently Asked Questions
- Using the IVR for Administration
- Installation Options
- Where to Go From Here
Configuring Voice
Configuring Voice Settings
Cisco SPA100 Series Phone Adapters Administration Guide 90
4
Line 1 and Line 2 Settings (PHONE1 and PHONE2)
Use the Voice > Line 1 and Voice > Line 2 pages to configure the settings for
voice services through the PHONE1 and PHONE2 ports.
To open this page: Click Voice on the menu bar, and then click Line 1 or Line 2 in
the navigation tree.
NOTE In a configuration profile, the FXS parameters must be appended with the
appropriate numeral (for example, [1] or [2]) to identify the port to which the setting
applies.
Enter the settings as described below. After making changes, click Submit to save
your settings, or click Cancel to abandon any unsaved entries.
Line Enable
Network Settings
Feature Invocation
Method
Select the method you want to use, Default or Sweden
default. Default setting: Default.
Field Description
Field Description
Line Enable To enable this line for service, select yes.
Otherwise, select no. Default setting: Yes
Field Description
SIP ToS/DiffServ Value TOS/DiffServ field value in UDP IP packets
carrying a SIP message. Default setting: 0x68.
SIP CoS Value [0-7] CoS value for SIP messages. Default setting: 3.
RTP ToS/DiffServ Value ToS/DiffServ field value in UDP IP packets
carrying RTP data. Default setting: 0xb8.
RTP CoS Value [0- 7] CoS value for RTP data. Default setting: 6.