Datasheet

5
Cisco 820 Series and SOHO Series Routers Cabling and Setup Quick Start Guide
78-13937-04
3: Connect a Digital Subscriber Line
Note You must use a crossover cable to connect a hub to an Ethernet port other than the ETHERNET 4 port
on Cisco 827H, Cisco 828, SOHO 77H or SOHO 78 routers. Crossover cables must be purchased
separately.
3: Connect a Digital Subscriber Line
Follow the steps in Figure 3 to connect an asymmetric digital subscriber line (ADSL) or G.SHDSL line
to the xDSL port on your router. Figure 3 shows back panels for ADSL and for G.SHDSL routers. Refer
to the back panel that is similar to the back panel of the router that you are installing.
Note The instructions in Figure 3 are for a straight-through ADSL cable, but they also apply if you are using
a crossover cable to connect your ADSL line. If you have microfilters or do not have the phone service
on the same line, use the lavender CAB-ADSL-RJ11 cable. If you have a splitter installed, use the
lavender CAB-ADSL-RJ11X cable with the blue stripe.
Figure 3 Connecting the Router to an xDSL Line
1 Cisco 828 or SOHO 78 router 4 Connect lavender cable to ADSL port on router.
2 Cisco 826, Cisco 827 series, or SOHO 76 or 77 series
router
5 Connect other end of cable to wall jack.
3 Connect lavender cable to G.SHDSL port on router. 6
ETHERNET 10BASE T
TO HUB
TO PC
43 2 1
Model Cisco 827 H
ADSL
CONSOLE
ETHERNET 10BASE T
TO HUB
TO PC
43 2 1
Model Cisco 828
G.SHDSL
CONSOLE
2. Connect other end of cable
to wall jack.
1. Connect lavender cable to
G.SHDSL port on router.
1. Connect lavender cable to
ADSL port on router.
Cisco 828 or
SOHO 78 router
Cisco 826, Cisco 827 series,
or SOHO 76 or 77 series router
74081