Technical Specs
Table Of Contents
- Cisco Connected Grid WPAN Module for CGR 1000 Series Installation and Cisco Resilient Mesh Configuration Guide (Cisco IOS)
- Cisco Connected Grid WPAN Module for CGR 1000 Series Installation and Cisco Resilient Mesh Configuration Guide (Cisco IOS)
- Hardware Overview
- WPAN Antennas, Connectors, and Cables
- Installing and Removing the Module
- Technical Specifications
- Information About Cisco Resilient Mesh and WPAN
- Configuring Cisco Resilient Mesh and the WPAN Module
- Configuring the WPAN Interface
- Configuring the CGM WPAN OFDM Module
- Configuring Adaptive Modulation
- Configuring Group Multicast
- Configuring RPL
- Configuring IPv6
- Configuring PON RPL
- Configuring the Power Outage Server
- Configuring QoS
- Configuring Cisco Resilient Mesh Security
- Configuring IPv6 Multicast Agent
- Configuring Dual-PHY WPAN
- Configuring DTLS Relay for EST
- Configuring Wi-SUN Mode
- Verifying Connectivity to the CGR
- show Command Examples
- Debugging the WPAN Module
- Sample Router Configuration
- Sample CGR and ASR Configuration
- Checking and Upgrading the WPAN Firmware Version
- Related Documentation
- Obtaining Documentation and Submitting a Service Request
Technical Specifications
Environmental Specifications
Following are the operating temperature ranges for the CGR:
• CGR 1120: -40 to 140 degrees F (-40 to 60 degrees C)
• CGR 1240: -40 to 158 degrees F (-40 to 70 degrees C)
Table 6: WPAN Module Environmental Specifications , on page 10 lists the environmental specifications for the WPAN module.
Table 6: WPAN Module Environmental Specifications
SpecificationsEnvironmental—Operational
-40 to 158°F (-40 to 70°C)Temperature—operational
Up to 1500 metersAltitude
RH95% non-condensingHumidity
1.0 g from 1.0 to 150 HzVibration
30 G half sine 6 ms and 11 msShock
GR63-Core, Zone 4Seismic
Physical-Layer Specifications
Table 7: List of Interface Default Values, on page 10 lists the interface default values.
Table 7: List of Interface Default Values
Default ValueParameters
EnabledAdministrative state
150 kbaud data rate, 75 bit rate due to FEC802.15.4 raw data rates
28 dBmMaximum RF transmit power
64 when using 902-to-928 MHz band (frequency hopping)Channels
3Link retransmission retries
Table 8: Default Frequencies of Channels , on page 11 lists the default frequencies for each channel.
10
REVIEW DRAFT - CISCO CONFIDENTIAL