Technical Specs
Table Of Contents
- Cisco Connected Grid WPAN Module for CGR 1000 Series Installation and Cisco Resilient Mesh Configuration Guide (Cisco IOS)
- Cisco Connected Grid WPAN Module for CGR 1000 Series Installation and Cisco Resilient Mesh Configuration Guide (Cisco IOS)
- Hardware Overview
- WPAN Antennas, Connectors, and Cables
- Installing and Removing the Module
- Technical Specifications
- Information About Cisco Resilient Mesh and WPAN
- Configuring Cisco Resilient Mesh and the WPAN Module
- Configuring the WPAN Interface
- Configuring the CGM WPAN OFDM Module
- Configuring Adaptive Modulation
- Configuring Group Multicast
- Configuring RPL
- Configuring IPv6
- Configuring PON RPL
- Configuring the Power Outage Server
- Configuring QoS
- Configuring Cisco Resilient Mesh Security
- Configuring IPv6 Multicast Agent
- Configuring Dual-PHY WPAN
- Configuring DTLS Relay for EST
- Configuring Wi-SUN Mode
- Verifying Connectivity to the CGR
- show Command Examples
- Debugging the WPAN Module
- Sample Router Configuration
- Sample CGR and ASR Configuration
- Checking and Upgrading the WPAN Firmware Version
- Related Documentation
- Obtaining Documentation and Submitting a Service Request
Naming the Notch
A notch is a list of disabled channels from the 902-to-928 MHz range. If there is no notch at all, then all channels are enabled. if there
is a notch [x, y], then channels between x and y are disabled.
Notch configuration must comply with your regional regulations (for example, a notch configuration is not required for U.S.). Notch
configuration must match between the WPAN interface of the CGR and the RME.
For sample configuration, see show wpan config, on page 55.
A channel list is a list of enabled channels.
Note
You can view the notch by using the following command:
Router(config-if)# ieee154 notch ?
<0-63> channel id
Router (config-if)# ieee154 notch 10-15, 30-35
Router (config-if)# end
Router# config in-hardware notch
notch: [10, 15]
notch: [30, 35]
Router# show wpan slot/port hardware channel-list
channellist: 0 1 2 3 4 5 6 7 8 9 16 17 18 19 20 21 22 23 24 25 26 27 28 29 36 37 38 39 40
41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63
Configuring the CGM WPAN OFDM Module
The following table shows the CLI interface commands for the CGM WPAN-OFDM Module.
29
REVIEW DRAFT - CISCO CONFIDENTIAL