Technical Specs

Table Of Contents

The Phy mode change causes the following config changes:

channel to 254; notch to none;

Adaptive modulation only supports to configure the same OFDM option phymode or the same OFDM option plus FSK

phymode.

Note

Use the following command to check PHY mode configuration:

#show wpan 4/1 hardware config

Configuring Group Multicast

Use the following commands to configure group multicast:

Enable MPL:

(config)#fan-mpl domain 0

Check the mcast address reported by node:

#show wpan 4/1 rpl mcast-info domains

#show wpan 4/1 rpl mcast-info groups

Add multicast agent interface (uplink interface):

(config-if)#mcast-agent interface fx/x

Add multicast agent port:

(config-if)#mcast-agent port

Add multicast agent group:

(config-if)#mcast-agent group-join ?

X:X:X:X::X multicast group address

Check multicast agent port, interface, and groups:

#show wpan 4/1 mcast-agent ?

group-join multicast group address

interface mcast-interface

ports Mcast optional ports

Configuring RPL

To determine the available RPL functions, query the rpl command:

Router(config-if)# rpl ?

dag-lifetime RPL DAG lifetime in minutes

dio-dbl RPL DIO dbl value

dio-min RPL DIO min value

route-poisoning Route poisoning

version-incr-time Version increment time in minutes

For more information about RPL, refer to "RFC 6550: RPL: IPv6 Routing Protocol for Low-Power and Lossy Networks".

Note

REVIEW DRAFT - CISCO CONFIDENTIAL