Technical Specs

Router (config-if)# outage server 2001:c1::8a43:e1ff:fec3:2aa
or
Router (config-if)# outage server nms.cisco.com
For sample configuration, see Sample Router Configuration, on page 62.
Configuring QoS
To specify a QoS service policy, use the qos service-policy command.
See the Quality of Service Solutions Configuration Guide Library, Cisco IOS Release 15M&T for QoS configuration information.
Configuring Cisco Resilient Mesh Security
RMEs use the IEEE 802.1X protocol, known as Extensible Authentication Protocol over LAN (EAPOL), for authentication.
Configuring Mesh Key
Router (config-if)# mesh-security ?
delete Delete the session(s)
expire Force Expire
set Set parameters
To set the mesh key, use the mesh-security set mesh-key command in privileged mode:
Router# mesh-security set mesh-key interface wpan <slot>/<port> key ?
Hex-string Key - even number (max. 32) of hex digits
Router# mesh-security set mesh-key interface wpan 3/1 key 1234567891234567 < --# Your secret key.
To configure the mesh key lifetime, use the mesh-security mesh-key command in interface configuration mode:
Only call this command if you are an expert mesh-security administrator.
Note
The Mesh-key lifetime value should be less than 120 days (10368000 seconds).
Note
Router(config-if)# mesh-security ?
authentication-timeout Set authentication timeout
keystore-update-period Set keystore update period
max-active-authentication Set number of parallel authentications
max-active-key-exchange Set number of parallel key exchanges
mesh-key Mesh key
Router(config-if)# mesh-security mesh-key lifetime ?
<60-2592000> Key lifetime (in seconds)
36
REVIEW DRAFT - CISCO CONFIDENTIAL