Technical Specs

no ip route-cache
ieee154 beacon-async min-interval 120 max-interval 900 suppression-coefficient 1
ieee154 panid 7224
ieee154 ssid migration_far2
ieee154 txpower -30
authentication host-mode multi-auth
authentication port-control auto
ipv6 address 2092:1:1:1::/64
ipv6 enable
ipv6 dhcp relay destination 2010:A0B0:1001:22::2
dot1x pae authenticator
mesh-security mesh-key lifetime 259200
end
Router# show run interface wpan 5/1
!<<<<<---- #Initially configured as slave
Building configuration...
Current configuration : 481 bytes
!
interface Wpan5/1
no ip address
ip broadcast-address 0.0.0.0
no ip route-cache
ieee154 beacon-async min-interval 120 max-interval 900 suppression-coefficient 1
ieee154 panid 7215
ieee154 ssid plc123
slave-mode 4
!<<<<---- #WPAN 5/1 has a master WPAN in slot 4
rpl dag-lifetime 240
rpl dio-min 21
rpl version-incr-time 240
authentication host-mode multi-auth
authentication port-control auto
ipv6 address 2091:1:1:1::/64
ipv6 enable
ipv6 dhcp relay destination 2010:A0B0:1001:22::2
dot1x pae authenticator
end
Check configuration of the slave module where slave mode displays the master-slot number as shown below:
Router# show wpan 5/1 config
module type: PLC-WPAN (IEEE P1901.2 PLC)
ssid: plc123
panid: 7215
transmit power: 32
ref-phase: 1
tonemap: unlocked (not used)
phy_params: 1 (ceneleca) 000000000FFFFFFFFF
beacon async: min-interval 120 max-interval 900 suppression-coefficient 1
security mode: 1
test mode: 0 (test firmware only)
admin_status: up
rpl prefix: 2091:1:1:1::/64
rpl route-poisoning: off
rpl dodag-lifetime: 240
rpl dio-dbl: 0
rpl dio-min: 21
rpl version-incr-time: 240
detach bridge: no
49
REVIEW DRAFT - CISCO CONFIDENTIAL