Technical Specs

Table Of Contents

bootloader mode: no

mcast-agent: FF38:40:2091:1:1:1:0:1 61624 1153

firmware version: 5.5.48

slave mode: 4

(slot 5 is attached to master slot 4)

Removing Slave Mode from Slave WPAN Configuration

Router#conf t

Enter configuration commands, one per line. End with CNTL/Z.

Router(config)# interface wpan 5/1

Router(config-if)# no slave-mode 4

!<<<<<---- #Ends slave mode to master-slot 4

Router(config-if)# end

Router#

Reloading the Slave WPAN

Router(config)# hw poweroff 5

Router(config)#

*May 22 12:42:15.511 PST: %CGR1K_SYS-5-MODULE_POWER_DOWN: Module in slot 5 is powered down.

Router(config)#

*May 22 12:42:17.539 PST: %LINK-3-UPDOWN: Interface Wpan5/1, changed state to down

*May 22 12:42:18.539 PST: %LINEPROTO-5-UPDOWN: Line protocol on Interface Wpan5/1, changed state to down

Router(config)#

Router(config)# no hw poweroff 5

*May 22 12:43:38.763 PST: %CGR1K_SYS-5-MODULE_POWER_UP: Module in slot 5 is powered up.

Router(config)#

*May 22 12:43:56.591 PST: %LINK-3-UPDOWN: Interface Wpan5/1, changed state to up

*May 22 12:43:57.591 PST: %LINEPROTO-5-UPDOWN: Line protocol on Interface Wpan5/1, changed state to up

Router(config)# end

Adding Mesh-Security keys for WPAN 5/1

Router# mesh-security set mesh-key interface wpan 5/1 key 5551

Key ID : 0

Key expiry : Sat Jun 21 12:55:43 2014

Router# mesh-security set mesh-key interface wpan 5/1 key 5552

Key ID : 1

Key expiry : Mon Jul 21 12:55:43 2014

There can be up to four mesh-security keys configured for a WPAN slot.

Note

Verifying that the WPAN is no Longer Configured as Slave

Router# show run interface wpan 5/1

Building configuration...

Current configuration : 467 bytes

interface Wpan5/1

REVIEW DRAFT - CISCO CONFIDENTIAL