Technical Specs
Table Of Contents
- Cisco Connected Grid WPAN Module for CGR 1000 Series Installation and Cisco Resilient Mesh Configuration Guide (Cisco IOS)
- Cisco Connected Grid WPAN Module for CGR 1000 Series Installation and Cisco Resilient Mesh Configuration Guide (Cisco IOS)
- Hardware Overview
- WPAN Antennas, Connectors, and Cables
- Installing and Removing the Module
- Technical Specifications
- Information About Cisco Resilient Mesh and WPAN
- Configuring Cisco Resilient Mesh and the WPAN Module
- Configuring the WPAN Interface
- Configuring the CGM WPAN OFDM Module
- Configuring Adaptive Modulation
- Configuring Group Multicast
- Configuring RPL
- Configuring IPv6
- Configuring PON RPL
- Configuring the Power Outage Server
- Configuring QoS
- Configuring Cisco Resilient Mesh Security
- Configuring IPv6 Multicast Agent
- Configuring Dual-PHY WPAN
- Configuring DTLS Relay for EST
- Configuring Wi-SUN Mode
- Verifying Connectivity to the CGR
- show Command Examples
- Debugging the WPAN Module
- Sample Router Configuration
- Sample CGR and ASR Configuration
- Checking and Upgrading the WPAN Firmware Version
- Related Documentation
- Obtaining Documentation and Submitting a Service Request
Example
CGR(config-if)#dtls-relay 2060:FACD::6 port 61629 max-sessions 10 lifetime 300
Use the following show command to verify the configuration:
#show wpan 4/1 config
Module Type: RF-WPAN (IEEE 802.15.4e/g RF OFDM)
ssid: 510P1-lzhao3
panid: 925
phy_mode: 149
band-id: 4
transmit power: 15
channel: 254
dwell: window 12400 max-dwell 400
fec: n/a
beacon async: min-interval 15 max-interval 60 suppression-coefficient 1
security mode: 1
test mode: 0 (test firmware only)
admin_status: up
rpl prefix: 2022:AAAA::10/64
rpl route-poisoning: off
rpl dodag-lifetime: 15
rpl dio-dbl: 1
rpl dio-min: 14
rpl version-incr-time: 10
detach bridge: no
bootloader mode: no
mcast-agent: FF38:40:2022:AAAA::1 61624 61628 1153
firmware version: 6.1(6.1.27)
slave mode: no
wisun mode: no
ieee154 beacon ver incr time: 60 seconds
DTLS Relay: 2060:FACD::6 max-sessions 10 lifetime 300
Configuring Wi-SUN Mode
Wi-SUN mode is supported from Cisco Resilient Mesh Release 6.1.
To enable Wi-SUN mode, use the following comand under interface configuration mode:
(config-if)#wisun-mode
• Changing wisun-mode requires module reload.
• In Wi-SUN mode, storing mode is not supported.
• In Wi-SUN mode, the mesh key should be reconfigured after changing PANID.
Note
Use the following command to configure wisun ucast dwell, bcast dwell, and bcast interval under WPAN interface:
(config-if)#ieee154 wisun-dwell ucast-dwell-int <125> bcast-dwell-int <125> bcast-int <500>
53
REVIEW DRAFT - CISCO CONFIDENTIAL