Technical Specs
Table Of Contents
- Cisco Connected Grid WPAN Module for CGR 1000 Series Installation and Cisco Resilient Mesh Configuration Guide (Cisco IOS)
- Cisco Connected Grid WPAN Module for CGR 1000 Series Installation and Cisco Resilient Mesh Configuration Guide (Cisco IOS)
- Hardware Overview
- WPAN Antennas, Connectors, and Cables
- Installing and Removing the Module
- Technical Specifications
- Information About Cisco Resilient Mesh and WPAN
- Configuring Cisco Resilient Mesh and the WPAN Module
- Configuring the WPAN Interface
- Configuring the CGM WPAN OFDM Module
- Configuring Adaptive Modulation
- Configuring Group Multicast
- Configuring RPL
- Configuring IPv6
- Configuring PON RPL
- Configuring the Power Outage Server
- Configuring QoS
- Configuring Cisco Resilient Mesh Security
- Configuring IPv6 Multicast Agent
- Configuring Dual-PHY WPAN
- Configuring DTLS Relay for EST
- Configuring Wi-SUN Mode
- Verifying Connectivity to the CGR
- show Command Examples
- Debugging the WPAN Module
- Sample Router Configuration
- Sample CGR and ASR Configuration
- Checking and Upgrading the WPAN Firmware Version
- Related Documentation
- Obtaining Documentation and Submitting a Service Request
test mode: 0 (test firmware only)
admin_status: up
rpl prefix: 2091:1:1:1::/64
rpl route-poisoning: off
rpl dodag-lifetime: 120
rpl dio-dbl: 0
rpl dio-min: 20
rpl version-incr-time: 60
detach bridge: no
bootloader mode: no
mcast-agent: FF38:40:2091:1:1:1:0:1 61624 1153
firmware version: 5.5.48
slave mode: no
• Use the install-firmware check command to determine the available WPAN firmware version integrated in the CGR image:
Router# config t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# interface wpan 4/1
Router(config-if)# install-firmware check
WPAN firmware version 5.5.48 is to be installed when executing "install-firmware release"
Upgrading WPAN firmware
There are two ways to upgrade the WPAN firmware:
• Upgrade from the current firmware (if older) to an integrated WPAN release firmware version.
• Upgrade from the current firmware to a WPAN firmware copied to the CGR flash.
Upgrading to the Release Firmware
To upgrade the WPAN module to the firmware version integrated in the CGR image, follow these steps:
Procedure
Step 1 Install the release firmware:
Example:
Router(config-if)# install-firmware release
Firmware upgrade starting. This may take several minutes. Please do not interrupt.
.....................
Installed the WPAN 5.0 firmware successfully (94 sec).
Please reload the WPAN module in slot 4!!
Step 2 Power down the WPAN module:
Example:
Router# config t
Router(config)# hw poweroff 4
Step 3 Wait for WPAN power-down messages, and then wait another 60-90 seconds. Then, power up the module:
Example:
82
REVIEW DRAFT - CISCO CONFIDENTIAL