Technical Specs

Table Of Contents

Router(config)# no hw poweroff 4

Step 4 Wait for WPAN power-up messages, and then wait at least 500 seconds before proceeding with any task on a WPAN

under reload. Then, check WPAN status and hardware version:

Example:

Router# show ip interface brief | inc Wpan

Wpan4/1 unassigned YES unset up up

Router# show wpan 4/1 hardware version

firmware version: 5.5.48, apps/bridge, master, 4b89e37, Apr 4 2014

Upgrading to a non-integrated WPAN firmware

You can upgrade to a custom WPAN firmware other than the one integrated in current CGR image. The appropriate WPAN firmware

image must be copied and available on the CGR flash in the root directory.

To upgrade the WPAN to a non-integrated, custom firmware, follow these steps:

Procedure

Step 1 Install the non-integrated firmware:

Example:

Router(config-if)# install-firmware <firmware-filename>

Firmware upgrade starting. This may take several minutes. Please do not interrupt.

.....

Step 2 Power down the WPAN module:

Example:

Router# config t

Router(config)# hw poweroff 4

Step 3 Wait for WPAN power-down messages, and then wait another 60-90 seconds. Then, power up the module:

Example:

Router(config)# no hw poweroff 4

Step 4 Wait for WPAN power-up messages, and then wait at least 500 seconds before proceeding with any task on a WPAN

under reload. Then, check WPAN status and hardware version:

Example:

Router# show ip interface brief | inc Wpan

Wpan4/1 unassigned YES unset up up

Router# show wpan 4/1 hardware version

firmware version: 5.5.48, apps/bridge, master, 4b89e37, Apr 4 2014

REVIEW DRAFT - CISCO CONFIDENTIAL