Technical Specs

Installing the Module
Follow these steps to install the module in an available slot in the CGR 1120 or CGR 1240:
Do not hot swap the WPAN module. Power down the module first.
Caution
Procedure
Step 1 Before you install the WPAN module within the host router (or remove the module), you must power down the router
as described in the Cisco 1120 Connected Grid Router Hardware Installation Guide or the Cisco 1240 Connected Grid
Router Hardware Installation Guide.
Step 2 Insert the WPAN module into the slot as shown in Figure 4: Inserted WPAN Module, on page 9.
Figure 4: Inserted WPAN Module
Step 3 Using a screwdriver, screw both captive screws into place.
Removing the Module
Follow these steps to remove the WPAN module from a slot in the CGR 1120 or the CGR 1240:
Do not hot swap the WPAN module. Power down the module first.
Caution
Procedure
Step 1 Using a screwdriver, loosen the two captive screws on the WPAN module.
Step 2 Gently pull the WPAN module out of the slot.
Cover empty module slots with a slot cover.
Note
9
REVIEW DRAFT - CISCO CONFIDENTIAL