Release Notes

7
Release Notes for Cisco 7600 Series Router Route Switch Processor 720 ROMMON
OL-17116-01
Upgrading the RSP720 ROMMON Using Cisco IOS Commands
Resolved caveats in 12.2(33r)SRE
The support for NabooCR boards was not included. The support is introduced in the ROMMON
Software Release 12.2(33r) SRE (CSCtl20213).
Resolved caveats in 12.2(33r)SRD6
The latency values in memory controller are not proper and Processor errata DDR20 was not
implemented. These problems are resolved in ROMMON Software Release 12.2(33r)SRD6
(CSCta53511 and CSCta77537).
Resolved caveats in 12.2(33r)SRD5
The latency values in memory controller are not proper and Processor errata DDR20 was not
implemented. These problems are resolved in ROMMON Software Release 12.2(33r)SRD5
(CSCta53511 and CSCta77537).
Resolved Caveats in 12.2(33r)SRD2
• Original on-die termination (ODT) configuration value is not correct. This could cause dual inline
memory module (DIMM) module failure upon bootup. This problem is resolved in ROMMON
Software Release 12.2(33r)SRD2 (CSCsq27958).
Resolved Caveats in 12.2(33r)SRC3
• After the non-volatile RAM (NVRAM) battery is switched, the route processor (RP) rommon cannot
boot with an image download. This problem is resolved in ROMMON Software Release
12.2(33r)SRC3 (CSCsm03389).
Resolved Caveats in 12.2(33r)SRB4
• The RSP720 and RSP720-10GE default RP ROMMON configuration register is set to 0x8000
instead of to 0x8002 to autoboot. This problem is resolved in ROMMON Software Release
12.2(33r)SRB4 (CSCsi92364).
Upgrading the RSP720 ROMMON Using Cisco IOS Commands
Before performing this procedure you need to download the new ROMMON image from Cisco.com.
The download procedure is the same procedure that you use for downloading the route switching
processor software images.
To download RSP720 ROMMON image from Cisco.com: