Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 21
application group
To enter the application group submode and define an application group, use the application group
command. To remove an application group, use the no form of this command.
application group
no application group group-name
Syntax Description
group-name
Application group name.
Syntax Description
Defaults
This command has no default settings.
Command Modes
Command mode
Usage Guidelines
When you enter the application group submode, the following commands are available:
 add protocol-specifier—Adds a protocol to the group. You only can add one protocol to a group
at a time (for example, HTTPS). This command allows you to group statistics for more than one
specified protocol into one counter.
To add two or more protocols to an application group, repeat the add command for each protocol. The protocols are
added only when you exit application group subcommand mode.
 cancel—Discards changes and exits from the subcommand mode.
 delete protocol-specifier—Removes a protocol from the group. You only can remove one
protocol from a group at a time.
To remove two or more existing protocols from an existing application group, repeat the delete command for each
protocol. The protocol is removed only when you exit the application group subcommand mode.
 exit—Saves changes and exits from the subcommand mode.
 help—Displays help and keeps you in the application group subcommand mode.
 name string—Sets the application group name.
You must provide protocol specifiers in the add or delete parameters, or both the add and delete
parameters.