Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 225
show waas device
To display the WAAS devices configured on the NAM device, use the show waas device command.
show waas device [ip-address]
Syntax Description
ip-address
IP address of the WAAS device (optional)
Syntax Description
Defaults
The default behavior is to show all WAAS devices unless IP address is specified.
Command Modes
Command mode
Usage Guidelines
This command is supported on all NAM platforms.
Examples
The following example shows the system inventory information:
[e-mail]# show waas device
[e-mail]#