Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 232
syslog remote-server
To capture NAM remote server alarms, use the remote-server subcommand from the syslog
subcommand mode.
remote-server disable | [server1 [server2] [server3] [server4] [server5]
Syntax Description
disable
Disables remote server event logging.
server1 server2 server3
server4 server5
(Optional) Specifies the remote server.
Syntax Description
Defaults
This command has no default settings.
Command Modes
Syslog subcommand mode
Usage Guidelines
This command is supported on all NAM platforms.
Examples
This example shows how to configure the NAM to capture remote server alarms:
root@localhost# syslog
Entering into subcommand mode for this command.
Type 'exit' to apply changes and come out of this mode.
Type 'cancel' to discard changes and come out of this mode.
root@localhost(sub-syslog)# remote-server 10.0.0.7 10.0.0.40
root@localhost(sub-syslog)# exit
NAM syslog settings updated successfully..
Related Commands
audit-trail enable
show syslog-settings
syslog