Reference Guide

Cisco Prime Network Analysis Module Command Reference Guide Page 39
config clear
To reset the NAM and return it to the factory-default state, use the config clear command.
Please note the behavior of this command has been changed since 6.0(2) release. The network IP
parameters will not be reset to factory-default starting from NAM 6.0(2) for config clear without
option.
config clear [all | ip]
Syntax Description
all
(Optional) Resets all NAM configurations to factory
default including the NAM IP parameters configuration.
The NAM reboots automatically for the changes to take
effect.
ip
(Optional) Resets NAM ip parameters back to factory
default. The NAM reboots automatically, and you must
session into the NAM from the switch supervisor engine
to configure the NAM IP parameters so that the module
can come online.
Syntax Description
Defaults
This command has no default settings.
Command Modes
Command mode
Examples
This example shows how to clear the configuration:
root@localhost# config clear
This operation will reset the NAM configurations with the exception
of NAM IP parameters.
This operation will also reboot the NAM to allow the changes to
take effect.
Do you wish to continue? (y/n) [n]:y
Successfully updated the SCCP configuration.
Successfully updated the H.323 configuration.
NAM syslog settings updated successfully.