Installation Guide

Important Safety Instructions
4035812 Rev B xv
Modifications
This equipment has been designed and tested to comply with applicable safety, laser
safety, and EMC regulations, codes, and standards to ensure safe operation in its
intended environment. Refer to this equipment's data sheet for details about
regulatory compliance approvals.
Do not make modifications to this equipment. Any changes or modifications could
void the user’s authority to operate this equipment.
Modifications have the potential to degrade the level of protection built into this
equipment, putting people and property at risk of injury or damage. Those persons
making any modifications expose themselves to the penalties arising from proven
non-compliance with regulatory requirements and to civil litigation for
compensation in respect of consequential damages or injury.
Accessories
Use only attachments or accessories specified by the manufacturer.
CAUTION:
Maintain electrical safety! Power-operated equipment or accessories that you
connect to this equipment should bear the UL listing mark or CSA
certification mark on the accessory itself, and should not be modified so as to
defeat the safety features. This will help avoid any potential for electric shock
or fire. If in doubt, contact qualified service personnel.
Mounting Accessories
CAUTION:
Use this equipment only with a cart, stand, bracket, table, or other
mounting accessories that meet Cisco specifications. Carefully follow
all instructions for proper mounting.
Electromagnetic Compatibility Regulatory Requirements
This equipment meets applicable electromagnetic compatibility (EMC) regulatory
requirements. Refer to this equipment's data sheet for details about regulatory
compliance approvals. EMC performance is dependent upon the use of correctly
shielded cables of good quality for all external connections, except the power source,
when installing this equipment.
 Ensure compliance with cable/connector specifications and associated
installation instructions where given elsewhere in this manual.
Otherwise, comply with the following good practices:
 Multi-conductor cables should be of double-braided shielded type and have