Installation Guide

Chapter 2 Installation
12 4035812 Rev B
2 Using the wall-mounting bracket as a guide, mark the location of four screw
holes in the mounting surface. Prepare the screw holes for installation as needed,
possibly by drilling pilot holes or installing wall anchors.
3 Install four #8 mounting screws (not provided) in the holes. Choose a thread
type suitable for the wall material, and leave the heads at least three threads
from the mounting surface.
4 Attach the mounting bracket (part number 4033734, included in accessory kit
part number 4036620) to the DAXI as follows:
 Place the DAXI upside-down on a firm surface with the DAXI wall-mounting
bracket resting loose on top.
 If necessary, flip the mounting bracket to position its keyed mounting holes
correctly with respect to gravity in the final installation. For example, when
mounting the DAXI facing left, position the keyed mounting holes so the
bracket slides over and down to lock behind the heads of the wall mounting
screws.
 Align the four mounting holes in the wall mounting bracket with the
mounting holes in the bottom of the DAXI.
 Install four #8-32 flat-head screws through the mounting bracket and into the
threaded holes in the bottom of the DAXI.
5 Holding the DAXI housing in its final orientation, slip the keyed holes in the
mounting bracket over the heads of the wall-mounting screws installed earlier.
6 Proceed to Connecting Cables to the DAXI (on page 14).