Installation Guide

Installing the DAXI
4035812 Rev B 13
To Install the DAXI in a Rack
The DAXI rack mount bracket holds one or two DAXI units and installs in a
standard 19-inch equipment rack.
Complete the following steps to install the DAXI in a rack.
1 Place the DAXI unit upside-down on the work surface.
Note: When mounting a pair of DAXI units, lay the units side-by-side with their
front panels facing the same direction and about one inch apart.
2 Lay the rack mount bracket (part number 4031305, included in accessory kit
4036620) on top of the DAXI unit(s) and line up the bracket with the four
mounting holes on the bottom of the DAXI housing(s).
3 Install four #8-32 flat-head screws through the mounting bracket and into the
tapped holes in the DAXI enclosure(s).
4 Invert the assembly and confirm that it appears as shown in the accompanying
illustration.
5 Install the assembly in an available 19-inch rack using four #10-32 machine
screws and compatible nuts. The screws should be long enough to extend at least
two threads beyond the outer face of the nut. Torque the screws from 25 to 30 in-
lb (2.8 to 3.4 Nm).
6 Proceed to Connecting Cables to the DAXI (on page 14).