Installation Guide

Chapter 2 Installation
14 4035812 Rev B
Connecting Cables to the DAXI
All input, output, and power connections to the DAXI are made via the DAXI back
panel, as shown in the following illustration.
To Connect the Output Cable
Insert the plug from the ASI cable in the jack labeled ASI OUT at far left on the DAXI
back panel.
Note: To allow for connection to an outside DSAN, the ASI output port is surge
protected, and the length of the ASI cable from DAXI to DSAN can be up to 250
meters of Belden 8281 or equivalent.
To Connect Input Cables
For the first auxiliary program source, connect the video output and left and right
audio output cables to the RCA jacks marked VIDEO 1, AUDIO 1 L, and AUDIO 1 R
on the DAXI back panel.
For each additional program source, connect the video and audio output cables to
the appropriate RCA jacks on the DAXI back panel.
Note: Double-check that all RCA cables are firmly inserted into their respective
jacks. These non-locking connectors can back out easily. Be especially mindful of this
using a BNC to RCA adapter on the video cable.
To Connect Power
Insert the plug from the +12 VDC power supply in the jack labeled +12V at far right
on the DAXI back panel.