Release Notes

Release Notes for 200, 300, 500, and ESW2 Series Switches Firmware Version 1.3.0.62 11
Release Notes
Problem: When a PoE switch is connected to another PoE switch, one of the
switches overcomes the internal power supply of the other PoE switch, so the other
PoE switch cannot provide PoE power to powered devices. If the connection
between these switches is removed, the switch that received power from the other
switch will momentarily lose its power and reboot. (CQ135360, CQ138875)
Solution: Disable PoE on the ports connecting the two PoE switches.
Problem: Given a stack configuration with the stack master as unit #2. On the Port
Vlan Membership page of the web-based interface, changing the value on the
Interface Type drop-down, the drop-down returns to unit #1. The information
displayed on the rest of the page belongs to the ports of the unit that was selected
using the drop-down. (CQ141909)
Solution: There is no workaround.
Problem: The routing resource “Used number of hosts” is not displayed correctly.
This is just a display issue, there is no user impact. (CQ133802)
Solution: There is no workaround.
Problem: In Layer 3 mode, SNTP Broadcast can only be operated from the CLI.
Solution: There is no workaround.
Problem: The EEE operational status should become disabled when Auto
Negotiation is disabled. (CQ132106 )
Solution: When the speed on a port is 1 Gigabit, auto negotiation has no effect on
the EEE functioning state.
Problem: The Voice VLAN should be prevented from being set as Guest VLAN,
and the user should receive a warning. This is not happening. (CQ132684)
Solution: Avoid setting the Voice VLAN as guest VLAN and vice-versa.
Problem: When the Mrouter learning mode is changed between “user defined” to
“auto” and vice-versa, the IGMP Querier election process does not start.
(CQ132805)
Solution: Disable IGMP Snooping and re-enable again, every time the Mrouter
learning mode is changed to start the Querier election process.