Release Notes

14 Release Notes for 200, 300, 500, and ESW2 Series Switches Firmware Version 1.3.0.62
Release Notes
Problem: When managing stacking switches through the web-based interface,
the loading time on the following web pages is more than 10 seconds: (CQ143851)
• Status and Statistics
• Port Management
• VLAN Management
• Access Control
• Quality of Service
Solution: Use the command line interface instead.
Problem: When the current master unit is already set to auto-numbering,
reconfiguring it as 'auto' does not work. (CQ142567)
Solution: Use the command line interface to configure this feature.
Problem: When configuring a manual IPv6 tunnel with EUI-64 format, the Global
IPv6 address is not created. (CQ140132)
Solution: Do not use the EUI-64 format when configuring an IPv6 manual tunnel.
Problem: You cannot configure ipv6 tunnel parameters if you previously did not
define the mode type. (CQ140919)
Solution: Configure the tunnel mode first when configuring an IPv6 tunnel.
Problem: You cannot run ping or traceroute by using a Domain Name on the web-
based interface. (CQ143759)
Solution: Use the command line interface instead.
Problem: When you are prompted to modify your password at the initial log in,
and then change the default password to use some special strings, the user will fail
to log in again with the modified password. An example of special strings would be:
like "Cisco100%+" or "WERab#%56". (CQ145271)
Solution: Use other passwords without special strings or use these strings as a
password after changing the password at least one time.
Problem: It is impossible to configure more than 255 multicast groups on an
Sx500 switch in Router Mode. The stated limit in the documentation is 1k multicast
groups. (CQ143282)
Solution: There is no workaround.