Release Notes

Release Notes for 200, 300, 500, and ESW2 Series Switches Firmware Version 1.3.0.62 15
Release Notes
Problem: There is a problem using PoE auto control via time-range. After
performing a save and reboot, the saved time-range configuration on port 4 is also
displayed on port 5 and 6. (CQ146121)
Solution: There is no workaround.
Problem: If you modify an IPv6 tunnel configuration, the change will not take
effect until you perform a shut then no shut on the tunnel interface. (CQ146071)
Solution: You must perform a shut then no shut the tunnel interface for it to take
effect.
Problem: The power inline server time-range function does not work.
(CQ146048)
Solution: Use the power inline auto time-range function instead, but you will need
to use an opposite time-range.
Problem: A global ipv6 address cannot be set in a tunnel interface when
following specific steps using the web-based interface. (CQ146027)
Solution: Reconfigure using the web-based interface, or configure it using the
command line interface.
Problem: When a 10G DAC (Direct Attached Cable) is connected to the copper
port of the SG500 using the last two ports (combo ports), the fiber link status
display might be up even when the link is not active. (no defect number)
Solution: There is no workaround.
Problem: Occasionally, a TACACS server that has been configured by using a
name cannot be deleted. (CQ146164)
Solution: Configure a TACACS server by IP address.
Problem: When enabling IPv6 unicast-routing, the interface cannot get an ipv6
address via auto-config. (CQ146156)
Solution: Configure the interface using a static IPv6 address.
Problem: When configuring a 500 series switch in L3 mode, the user is allowed
to configure the TCAM for IP4 and IPv6 routing resource on the same web page.
(CQ146267)
The issue occurs on the backup switch in a stack. Refer to the following steps as
an example: