Release Notes

Release Notes for 200, 300, 500, and ESW2 Series Switches Firmware Version 1.3.0.62 5
Release Notes
Contents
Hardware Versions, page 5
Major Changes and Defects Corrected, page 7
Limitations and Restrictions, page 9
Where to Find Support, page 17
Hardware Versions
The Release 1.3.0.62 firmware runs on two different versions of hardware for the
200 Series Smart Switches, and the 300 Series Managed Switches. There is a
single version of hardware for the 500and ESW2 series switches. The number of
supported MAC Addresses, Active VLANs, and Multicast Groups will be different
depending on which version of hardware you are using. Refer to the following
table for details:
V1 versus V2 Hardware Total Number
of MAC
Addresses
Total Number
of Active
VLANs
Total Number
of Multicast
Groups
Sx200 in Firmware 1.0.x
HW VID=01
8K 128 128
Sx200 in Firmware 1.1.x
and above.
HW VID=01
8K 256 256
Sx200 in Firmware 1.1.x
and above.
HW VID=02
8K 256 256
Sx300 in Firmware 1.0.x
HW VID=01
8K 256 256
Sx300 in Firmware 1.1.x
and above.
HW VID=01
8K 256 256