Release Notes

8 Release Notes for 200, 300, 500, and ESW2 Series Switches Firmware Version 1.3.0.62
Release Notes
issue does not occur on the CLI, because the CLI will not permit two ACE to
be created on one ACL. (CQ147329)
• After a static IPv4 route is configured on Sx300, this route is not displayed
on WEB GUI though this route works fine. However, it can successfully be
displayed in CLI, and it does not matter whether this route was created via
CLI or GUI. (CQ147056)
• After the firmware is upgraded from 1.2.9.44 to 1.3.0, the IP default gateway
changes to default route. (CQ146158)
• In the router mode and default configuration, whenever the DHCP IP
address is renewed, the previous entry in the table is not removed. After a
while the following message is displayed – “17-Apr-2013 06:51:03 :%ARP-
E-ARPTBL: ARP Table Overflow”, and the TCAM is exhausted. (CQ147161)