Installation Guide

Installing/Removing the Blank Panel
To Install the Blank panel
Blank panel is an optional component. Users can purchase, mount and dismount
the blank panel according to their own needs. When all required application
module are installed and there are still empty slots on the chassis, you need to
install blank panels. Detailed installation process is as below:
1. Select an empty slot.
2. Hold blank panel vertically with panel front towards you.
3. Align the top of the blank panel with the upper guide slot of the frame.
4. Align the bottom of the blank panel with the lower guide slot of the frame.
5. Tighten the mounting screws on the lower front panel of the panel by hand
or screwdriver, to secure the panel in the chassis.
Note: The torque of mounting screw is 5 - 6 kgf·cm.
6. Repeat the steps above if more panels need to be installed.
To Remove the Blank Panel
1. Loosen the mounting screws on lower front panel of the module by hand or
screwdriver, to release the module from the chassis.
2. Pull out the blank panel slightly to unseat the chassis.
OL-29659-03 Installation 2-11